Jan 27, 2013 · Should I use a larger shaft? what is the proper technique to weld the auger flighting? You can stretch / twist them to make them fit tighter, not any easy task but that will probably snug it up. Watch about welding long beads as it can bow the tube. Most important weld is the top / discharge end.

Feb 24, 2011 · When welding the flighting back on your tube simply tack weld every 12" or 18" (use the old weld pattern as a guide). Be sure to rotate the weld spots around the shaft so they are not all on one side. Overwelding or welding on one side can cause the tube to warp.

Dec 15, 2024 · Our Honda HS928 auger holes had gotten enlarged due to loose shear bolts. We opted for a quick fix and had them welded shut for a mere $20. However, redrilling the holes proved to be a bit of a challenge.

Oct 5, 2023 · Remove the old auger and take it to a welding shop that does this stuff a lot. As others have said you will need to stretch it. Most flighting is cupped so make sure you get it on the right way. The flighting is usually harder than your weld so weld on the back side away from the grain or your welds may wear off before flighting is worn.

Welding your flighting to your auger can be tricky and there is always a risk of your auger not performing properly if done incorrectly. There are tips and tricks to help ensure a straight, tight fit, but it's best to speak to an expert if you need help.

Oct 19, 2015 · My Yamaha had a welded auger, worked fine. But if you are damaging them that much in normal use I would imagine that the repaired augers will just get mangled up again. You may want to look at another machine with something sturdier out there.

Nov 21, 2010 · To make an auger you would select the correct feed rate for the pitch, mount an arbor, and hit the air valve for the "tail stop". Select the flight guide and adjust it for height and angle. Leaning the guide left and right was very important …

Jan 23, 2011 · The sections are then tack welded to the shaft aligning the outer edges to give a smooth auger flight and you have yourself a heavy section auger albeit with a few small gaps generally along the shaft that will be welded up.

Mar 2, 2008 · One 1.5 weld or so every 4th flight is enough if its stretched and welded good on both sides at the ends. then roll it over and do another 1.5 weld every 4th flight between the ones on the other side. This helps balance the auger.

The IRWIN® with WeldTec™™ ship auger is made stronger and lasts longer than any standard augers. It features a welded cutting\nedge that easily cuts through tough materials like nail-embedded wood. It has twice the nail cutting life of standard ship augers.