Apr 19, 2024 · For my Vortec/LS Swap guy, how did you guys suggest or wire the VSS from the Chevy PCM from the Jeep three wire harness? I am running a manual transmission and have the 1994 three wire harness. I have a Dakota Digital SGI-100BT to make the conversion work, but I can not get the signal to transfer.

Apr 22, 2019 · 2017 - 2022 Super Duty - Where is the VSS (vehicle security system) module on a 2018? - Trying this another way, didn't get any takers on my previous thread. I have a long range extender antenna for the remote start and believe it plugs into the VSS module.

Sep 18, 2014 · When truck moves w/manual tranny in neutral, idle increases to over 1500 rpm. When truck stops, idle goes back to normal. Don't know if faulty VSS is to blame. It is located …

Download this free chapter from our manual Chevrolet TPI & TBI Engine Swapping, which covers how to install vehicle speed sensors (VSS) in order to make V8 engine swaps work the way they should. A few images from the chapter follow.

JTR Stealth Conversions began offering aftermarket vehicle speed sensors (VSS) for engine swaps in 1991. Our speed sensors are smog legal for engine swaps and have been issued CARB EO #D-371. The VSS tells the Engine Control Module (ECM) how fast the vehicle is going. Most people think the VSS is only used for the lock-up torque converter.

VSS’ v8/v12x4 Distributed TAPs are entry-level, lower port density 1G Distributed Series models. The v8 has eight UTP ports and the v12x4 Distributed TAP has 12 UTP (or Fiber LC) ports and 4 SFP ports. Any port can be designated an input port or output port**. In the case of the copper version (UTP), the

Sep 13, 2016 · If it's possible to adjust the VSS calibration with a tune, then I may be able to get by with just fabbing a bracket so that the VSS reads the ABS tone ring outside of the dif case. Ford has the ABS sensors setup that way from the factory.

May 3, 2012 · On a VS V8 Auto engine loom, there is: -A 7 pin connector near the ECU (containing ALDL, Diag test enable, fuel usage signal, VSS signal to speedo, ECU IGN supply, pwr/econ switch signal) -A 6 pin connector (Battery +, Injector +, Fuel pump etc)

Jun 18, 2011 · so i ended up spending the $380 on the adaptor recently only to start looking at tuning the motor myself, and after looking on TP5 i see that you can change the vss pulse rate!!! am i right in thinking i could of wired up the electronic nissan speed sensor on my 4x4 and changed the pulse rate on the tune to suit? by The1 » Tue Jun 21, 2011 8:05 am.

Oct 21, 2021 · New vehicle speed sensor adapter harness allows you to plug in a 90-92 TPI wiring harness into an 89 or older Camaro/Firebird 700R4 or T5 transmission. Harness plugs in without splicing, and elimates the need to replace the …