Sep 13, 2020 · Looking up from the brake pedal there is just a plastic walls. Looking from under and to the side of the headlight switch where it should be visibility very limited even with a mirror. Ran me hand in there and can't feel any bolts or wire bundles that would relate to the ground.

Feb 12, 2014 · A forum community dedicated to all jeep owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!

Dec 12, 2020 · G108, which says it's near the Headlamp switch. Which ultimately grounds to chassis through the two large bolts on either side that hold the dash up. Did somebody change the heater core and maybe not tighten those bolts down?

Mar 1, 2012 · Your instrument cluster has a ground at ground post G108. The wire is an 18 ga Black/light green tracer. G108 located on the dash frame near the headlmp switch.

Feb 14, 2019 · Its down behind the knee bolster under the gauge cluster, there are two different grounds in that area that are listed G108. 99 4.0/AW4/231, with a few basic bolt ons. You must log in or register to reply here. another No Bus and faulty instrument cluster thread...

Feb 7, 2010 · Jeep Cherokee Electrical Problems: Bad Ground Points & Connectors This page shows the areas you should ensure are well grounded. A =LOT= of wierd engine behavior is caused by poor grounds, especially on early XJ's!

G108 NearPowerDistributionCenter 6,7 G200 NearAirbagControlModule 24,27,28,29 G201 NearAirbagControlModule 24,27,28,29 G300 NearRightFrontSeat 42,44 G301 NearLeftFrontSeat 41,43 8W - 91 - 12 8W-91 CONNECTOR/GROUND/SPLICE LOCATION WJ CONNECTOR/GROUND/SPLICE LOCATION (Continued) Title: 18720-wj_intlpdf.pdf

Oct 29, 2014 · When I first picked up my XJ the gauge cluster would work intermittently, now it does not work at all. I don't think the the cluster itself is the problem. I've searched and found the thread below and followed most of the procedures performed there, and …

Check for 5 volt circuit short to ground or loose ground at pcm... The root cause is usually one of the two 5 volt supplies shorted to ground. If so, this will lock up the PCM and you will experience a die out, NO BUS, and a NO RESPONSE problem. The PCM will put out 5 volts on pin a17 (k7) and pin b31 (k6) when the PCM is powered up.

Jun 4, 2011 · 2011 Grand Cherokee, matching 20" rims, limo tint, 6000K HIDs, LED reverse lights, and more to come. So not one really close to the trunk. Just measure any existing bolt on the trunk floor to a known ground point to be sure its ok. KYB Gas-a-Just shocks / Transgo reprogramming shiftkit.