Jun 30, 2024 · Port Channel and Virtual Port Channel (vPC) are both technologies used in networking to aggregate multiple physical links into a single logical link for increased bandwidth and redundancy. They are related, but they have some key, distinct differences in terms of architecture and use cases. Port Channel (EtherChannel)

Feb 27, 2007 · A port channel is the logical representation of the etherchannel on the switch. Once you have configured an etherchannel you make all you changes on the port channel interface and these will be automatically applied to all …

Jun 2, 2013 · Al final era mas facil que todo eso, es hacer 2 port-Channel en el Switch Catalys 2900, sin conectarse al Catalyst 4500. Lo he configurado de la siguiente forma. interface Port-channel2. switchport access vlan 200. switchport mode access! interface Port-channel4. switchport access vlan 200. switchport mode access! interface GigabitEthernet0/3

Sep 18, 2018 · I have the port channel and two fiber channels setup as trunk ports. I'm using a SVI on the Meraki and Nexus core for routing. I used channel-group 112 mode active to add the ethernet ports to channel group. It works, but not sure this is the best way to handle it. I'm having problems with Meraki pulling a Management IP address. I'm use to ...

Feb 19, 2014 · We're trying to configure a port channel group with trunked ports to connect a NetApp HA pair. We want to create two data LIFs and connect them to the switch stack. We are trying to create 2 data lifs, one for cifs and one for nfs that are on different vlans.

Dec 6, 2024 · - Ensure that interfaces are no longer part of the port channel and are in the up/down or down/down state (depending on whether they are connected to active devices): show interface status. 4.Remove Port Channel Configuration: - Once all interfaces are removed from the port channel, delete the port channel itself: no interface port-channel40. 5.

Oct 31, 2013 · If port channel 16 is on these ports clear it and bounce the port channel. Check each side for ports in the channel with the show etherchannel sumary command , it should only show one port on each side . If there is more than 1 thats your issue and check those other ports and remove them if need be. Oct 31 16:22:15.287 PDT: SW1: FEC: pagp ...

Feb 1, 2015 · I recently joined a company as a network engineer, most of the networking task has been implemented by previous employee. I'm looking into configuration of the network. lots of portchannel is being already implemented. I'm looking for a command to see the whole properties of a specific portchannel f...

Oct 13, 2018 · Add the physical interfaces to channel-group which corresponds to Port-Channel. Note that the! port-channel and channel-group number should match for all physical ports to be part of the ! same bundle interface ethernet 1/29, ethernet 2/30 switchport mode trunk switchport trunk allowed vlan all switchport trunk native vlan XX channel-group 1 ...

Dec 13, 2019 · はじめに Link Aggregation Control Protocol (LACP)とは複数の物理的なポートを束ねてひとつの論理的チャネル(Port-channel)として扱うためのプロトコルのことです。IEEE 802.3ad に規定されています。 LACP による port-channel を形成する利点 複数の物理的なポートを束ねて、Port-channel として扱うことのメリットは ...