Mar 17, 2024 · In researching my ABS module issue I recently have noticed the brake fluid leaking out from under the cap. Dealer wanted $35 for a new cap. Auto Zone had one in stock for well under $20. Since replacing the cap my issue hasn't completely gone away as I wait for a new ABS Control Module.

May 14, 2022 · I had the same issue with my ABS Module as all of you are describing above on my 2012 Jeep Wrangler JK. I lucked up and found Module Master online. $250, plus shipping all is back to normal. Best decision I made.

Feb 18, 2022 · I was continuing to get C2200 even after all the CELs and ABS was cleared with the JSCAN. Everything online and apparently in the manual tells you the fix is a new or rebuilt ABS module. I kept clearing the codes and realized the JSCAN allows you to go into the ABS module and select all the valves, etc and open/close them. While parked.

Feb 28, 2014 · ABS and traction control are tied into the same system in modern vehicles, so maybe there is a low brake fluid level that is triggering all three lights. 1993 Wrangler S 2.5L/AX-5/NP231 with SYE, Spartan locked Dana 30/Aussie locked Ford 8.8 @ 4.88, SOA lift with 2.5" OME HD springs and front Bilstein/rear Rancho shocks, Barricade 9500 winch ...

Aug 3, 2024 · I have the Jeep Wrangler 2016 75 th Edition. Had the breake, traction control, abs, and check engine light. Took it to the dealer 3 months ago. Just call the dealer and was told it was moved to the end of October before they can order one. They also added the abs module is being redesigned. Meanwhile my Jeep is parked on my driveway.

Jul 13, 2024 · Fix the angle sensor, the abs code goes away. For another unfortunate example, I have a periodic camshaft position sensor code that on occasion will trigger a C121C abs code. The abs code is triggered by the CPS code - no doubt about that. Neither is a fault with the ABS system. inb4 just replace your camshaft sensor.

Nov 21, 2023 · I have a 2009 JK that is throwing a C2200 (ABS Controller failure). The Freeze frame is showing 10.66v so I think I may have a power or ground issue. I'm looking for the power and ground wires to make sure the correct voltage is making it to the controller. I've already pulled the main connector and reseated it with no change.

Jul 29, 2022 · Perform ABS Brake Bleed Procedure So now we're ready to perform the ABS Brake Module Bleed using OBD Jscan app. Note from original poster: This is a 2 person job, where one person will need to hold the Brake pedal while the other opens the bleeder valves. It is likely not a good idea to attempt to wedge something in your JK to hold the brake ...

Apr 16, 2021 · I have a 2009 4 door JK base model and it is throwing code C2200 - ABS module internal fault; only when driven over 10 mph. Now normally when a module goes bad I just chuck a new one in there and it's fine, but this code has been somewhat intermittent over the past few years so I have been trying to fix it rather than just throw a part at it ...

May 26, 2023 · The traction control lights and ABS lights are on due to the following reasons: ... 12 JK,2.5" Teraflex ...