If you have a 3D printer, chances are, the company you bought it from skimped out on the design of their filament holder. It’s okay though, it’s not like having a toilet roll holder for your ...

[Mark] made a spool holder that can accept 2 different width spools. This design uses skate bearings to support the spool on two points at each end. There are 3 sets of bearing blocks to ...

The sample spool holders on Thingiverse were either too small for the 165mm internal diameter, or were adjustable but complex. It didn’t take long with Design Spark Mechanical to knock up a design for ...

Plus, certain printers, including a couple of Ender 3 models, have better filament feed once you realign your custom spool holder or add some support brackets to the basic holder included in your ...

I often need to load filament and then take a photo of it in the AMS – or my Prusa XL’s spool holders – then refer to the photo to configure the slicer. Worse yet, when files are pre-colored by the ...